RESOLVED: I'm not really sure how this fixed it but it is fixed. After working with Support, here are the steps that they sent to me that I took: "Step 1, Select two MoCA adapters, connect them directly with a short coaxial cable. Power up them, check the link rate. Hope we can get about 3500Mbps. Step 2, If Step 1 is OK. Please connect the two MoCA adapters to the 2-way splitter with short coaxial cables. Please don’t use the in wall coaxial cables. Just use short coaxial cables. Power up them, check the link rate. If the link rate is OK, that means the 2-way splitter is good. Step 3, If Step 1 is OK. Please connect the two MoCA adapters to the 6-way splitter with short coaxial cables. Please don’t use the in wall coaxial cables. Just use short coaxial cables. Power up them, check the link rate. If the link rate is OK, change to other output ports and check again. If all ports has the correct link rate, that means the 6-way splitter is good." When I took these steps, I was getting 3500+Mbps. I then hooked everything up the EXACT same way I got it (same cables and everything) and now I have the 3500ish Mbps Not sure how this fixed it but at this point, I will just call it magic and move along. 😁

I have this one connected where the PoE is: https://www.amazon.com/gp/product/B0113JAN8K/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1 The modem is connected to that and then splits off to this one: https://www.amazon.com/gp/product/B01M34OZ2S/ref=ppx_yo_dt_b_asin_title_o01_s01?ie=UTF8&psc=1 I only use 5 of those ports and have capped the unused ones with 75 Ohm terminators. I thought Bamf was a good brand?

At Step 4, did you make sure to change the subnet mask and the default gateway? Make sure the subnet mask is the same as your router and then make sure that the gateway would be the IP of your router (192.168.0.1).