I just purchased two MA2500D, followed the correct topology, placed a POE filter at the line coming in. I did the IP address static setup for each unit as well. However, neither seem to adopt an IP address when plugged into the router or on the other end. Also I tried to download the firmware upgrade but the file seems corrupt. I am using a Mac, with tp link Omaha EAP's, switch, and an arris surfboard s33. Would appreciate any advice. Thanks
top of page
To see this working, head to your live site.
10 Comments
Finally got things working. I think the splitter outside my house had some bad ports and once I switched the line everything worked like a charm, getting 900+ mbps wired which is great. The AP showed up to be provisioned and added to my tp link Omaha controller. I did not end up using any of POE filters and otherwise kept the diagram the same. Also was able to upgrade both adapters to the newest firmware.